Esoteric RZ-1 El manual del propietario descargar pdf (Pagina 22)

Setup Mode

Changing settings

Press and hold the SOURCE button for more than

2 seconds to enter the setup mode.

Hold down

more than 2 sec.

The setup indicator ( ) and setup item appear on the

display.

< You can also use the SETUP button on the remote control

unit. (This button does not need to be pushed for more than

2 seconds. It will start setup mode immediately.)

Press the SOURCE button repeatedly to select an item.

Each time the SOURCE button is pressed, the item changes as

follows:

BAL

TREBLE

BASS

L-2

DIMMER

Return to the previous display

(Exit setup mode)

Speaker balance

Level of high frequency sound range

Level of low frequency sound range

Digital lter

LINE2/PHONO terminal

< You can also use the SETUP button on the remote control unit.

< If no button is pressed for more than 10 seconds, the setup

mode will be canceled and return to the previous display.

Press the VOL (+/−) buttons to change the setting.

< You can also use the INPUT ( / ) buttons on the remote

control unit.

See “Available setup items and settings” on the next page for

Individual setting.

Repeat steps

and

as required.

Press the SOURCE button repeatedly to exit the setup

mode.

< If one of the following buttons is pressed, the setup mode will

be canceled:

Eject button (L/H)

STOP button (H) on the remote control unit

CLEAR button on the remote control unit

< Memorized settings are stored even after the power cord has

been disconnected.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Comentarios a estos manuales

Sin comentarios

Esoteric RZ-1 El manual del propietario Pagina 22

Comentarios a estos manuales